BlueNRG-1 Automatic Connection after pairing

Dear Tino,

please notice that the connection establishment procedure is always up to the Central device (the iPhone in your case) and not up to the Peripheral (BlueNRG-1 in your case).

If BlueNRG-1 is advertising correctly, then your phone should be able to find it during scanning.

If you want your iPhone to connect automatically to the BlueNRG-1, you should do it programmatically from iOS side.

Best regards,

Antonio

Hello Antonio,

thank you for your answer. But I have one question: Do I need an own app to connect automatically?

I think when the phone is paired with the BlueNRG-1, that the phone connects automatically to the board and I have nothing to do. Is it wrong ?

Dear Tino,

what is the program you are running on the BlueNRG-1 Peripheral?

Kind regards

Andrea

I write an own program on the BlueNRG-1 Peripheral.

In the Init Function I send the following functions:

ret = aci_gap_set_io_capability( IO_CAP_NO_INPUT_NO_OUTPUT );

ret = aci_gap_set_authentication_requirement( BONDING, MITM_PROTECTION_NOT_REQUIRED, SC_IS_NOT_SUPPORTED, KEYPRESS_IS_NOT_SUPPORTED, 7, 16, DONOT_USE_FIXED_PIN_FOR_PAIRING, 123456, STATIC_RANDOM_ADDR );

When I connect my phone with the BlueNRG-1 Board I get the follwing Event:

hci_le_connection_complete_event.

I send after 2s:

ret = aci_gap_slave_security_req( connection_handle );

Now I get the Event 'aci_gap_pairing_complete_event' but when I reconnect the BlueNRG-1 I get no automatically Connection to my board.

One option to check the correctness of the security setting could be comparing your current configuration with the one implemented by the BLE_Security example included in the official

http://www.st.com/content/st_com/en/products/embedded-software/evaluation-tool-software/stsw-bluenrg1-dk.html

Dear Andrea,

I test the BLE_Security example for the STSW-BLUENRG-1-DK, but I have two problems:

1. When I start the Pairing process everything works fine, but after 30s the Connection lost to the board. Why?

2. I have the same Problem before. After a Pairing and a reset my board, the IPhone doesn´t connect to the board again

Dear Tino,

couldyou checkifsuch issue/behavioris also experienced with a mobile based on Android? For this use case, maybe

Marchese.Graziella