Cannot reenable BSPI1

Posted on September 09, 2005 at 12:35

Hello,

I have a PCB with 142 pin connected to a pull-up resistor.

I use correctly a spi flash. After a minute, I enter in LPWFI mode and disable BPSI1 by a BSPI_Enable (BSPI1,DISABLE); command

After an interrupt, the program restart and enable the bspi but the BPSI1 component detect a bus error.

I don't understand why.

Thank's,

Posted on September 09, 2005 at 12:48

Sorry,

In fact the pin GPIO0.7 was used somewhere else.

My mistake