FlashBash Programmer

Posted on September 16, 2004 at 03:04

dear sjo,

I have maked one FLASHBASH(use St72C264G2), but it doesn't work. it failed when I use ''FLASHBASH windows software''.

I have used the the new version of pcb and and withot serial communication my pcb works. it seems that falshbash software on windows can not communicate with the pcb. when i try to do every funtion wich needs to communicate with pcb I get the failed message.

would you please help me to solve this problem.

regrds

S.E.Alavi

Posted on September 16, 2004 at 11:44

Both the hardware and software have been extensivly tested so double check your pcb and software versions.

If you have built the source then check #define SOFTUART has been commented out if using the 264.

The s19 files on the website are built by default for the 264 (from v1.07).

Regards

sjo