Skip to main content
M
mbr972
Associate
November 30, 2024
Question

stm8s105k6c6

  • November 30, 2024
  • 1 reply
  • 1212 views

 

Hello, 

I'm looking to read and write on an stm8s105K6c6 of a hoover, and would like any information that would enable me to carry out these tasks (chip and st-link v2 wiring diagrams), as well as the most appropriate software...

Thank you

*This post has been translated from French to comply with the ST Community guidelines.

    1 reply

    Peter BENSCH
    Peter BENSCH
    Technical Moderator
    November 30, 2024

    Welcome @mbr972, to the community!

    I would be very surprised if the manufacturer of the hoover had not protected the IP of the STM8 with the ROP function (see data sheet, section 4.4). I am therefore not holding out any hope that you will be able to realise your project successfully.

    Regards
    /Peter

    In order to give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.
      M
      mbr972Author
      Associate
      December 1, 2024

      Merci, je suis novice en la matière. Et veux tenter l'expérience, j'ai acheté une stm8s105k6t6, mais je ne sais pas les correspondances entre le st-link et la puce, du moins pas de certitude. 

      RST= NRST pin 1

      SWIN= PD1 SWIN pin 42

      SWCLK= PD0 pin 41

      SWDIO= VDDIO_1 pin 8

      3.3v = VDD pin 7

      GND= VDDA pin 13

      Merci cordialement 

      Terms & ConditionsAccessibility statement