Question
failed to start debugging on STM32F0308-Discovery board with OpenSTM32
Posted on October 23, 2016 at 23:15
.ExternalClassE6B9D6A715684DEB9AF9BCF83BCA0443 pre.cjk {font-family:'Courier New',monospace;} .ExternalClassE6B9D6A715684DEB9AF9BCF83BCA0443 p {margin-bottom:0.1in;line-height:120%;}
I�m be interested to use OpenSTM32, as it runs across platforms of Linux,MacOSX and Windows,
with Eclipse and plugins to integrate Gnu ARM GCC and OpenOCD.But I get a problem when try to start debugging session on the board of STM32F0308-Discovery.
I have the all toolchain installed and updated to latest. Start debugging on STM32F0Discovery
board is all fine.The failure message on STM32F0308-Discovery says timeout and failed on holding reset,
and further information seems prompt a failure on erasing flash. I tried to invoke Target=> Erase chip, from OpenSTM32, and it failed on timeout. However, when I try to use �ST-Link Utility� to erase and programing the board of STM32F0308-Discovery, it went through all fine. And also, I have another set of wrapper tool over OpenOCD, can start debugging session properly, which of course means of erase/programming the flash on STM32F0308-Discovery properly.So, after all, I have the question to the configuration file on OpenOCD for
STM32F0308-Discovery and STM32F0Discovery. I know they are been provided differently, the question is, what the essential difference need to be between the two of OpenOCD configure file? Please help. #openstm32 #stm32f0308 #openocd