L6472 Stepper Driver - Does the max/min speed register value conform to the selected step mode or is it always in terms of whole steps?

I am driving a 200 step per revolution motor. The position register per the data sheet conforms to the selected step mode so 1/16 micro stepping results in 3200 steps per revolution. I would expect that the max/min speed registers would conform to that as well so 200 steps/sec would result in a full revolution taking 16 seconds (ignoring acceleration and deceleration). That does not appear to be the behavior as 200 steps/sec takes roughly 1 second regardless of the step mode. I just want to confirm that this is the correct behavior.