I am using the STEVAL-25R300KA board with ST25PC-NFC version 3.0.2 on a PC running Windows 11.The software opens for a few seconds and then closes automatically by itself. I have already tried the following steps:Reinstalled the softwareRestarted my PCInstalled both x64 and x86 versions of the Microsoft Visual C++ Redistributable packagesChecked the Windows Event Viewer / Journal logs for any related errorsUnfortunately, none of these steps resolved the issue, and no specific error was detected in the logs.Could you please let me know what I can do to fix this problem and use the software properly?Thank you for your support.

Visitor II

Question

ST25PC-NFC program crashing on windows 11 ?

I am using the STEVAL-25R300KA board with ST25PC-NFC version 3.0.2 on a PC running Windows 11.

The software opens for a few seconds and then closes automatically by itself. I have already tried the following steps:

Reinstalled the software
Restarted my PC
Installed both x64 and x86 versions of the Microsoft Visual C++ Redistributable packages
Checked the Windows Event Viewer / Journal logs for any related errors

Unfortunately, none of these steps resolved the issue, and no specific error was detected in the logs.

Could you please let me know what I can do to fix this problem and use the software properly?

Thank you for your support.