Wakeup from standby with RTC on STM32C5

Hello,

I am using the RTC wakeup from the power standby example provided in the STM32C5 repository. The example starts the RTC wake-up timer and places the device in standby mode. The device does go to standby, and it does wake up due to the RTC wakeup interrupt; however, the RTC initialization fails after wakeup. It is worth mentioning that the only way I can get rid of this error is to power cycle the board.

The failure happens in HAL_RTC_WAKEUP_SetConfig due to RTC_WaitSyncrhroWUTW() returning an error due to  RTC_CR_WUTE being set.

static hal_status_t RTC_WaitSynchro_WUTW(void)
{
 uint32_t tickstart;

 if (LL_RTC_IsActiveFlag_INIT() == 0U)
 {
 if (LL_RTC_WAKEUP_IsEnabled() == 1U)
 {
 return HAL_ERROR; // Code returns this error
 }
 tickstart = HAL_GetTick();

 while (LL_RTC_IsActiveFlag_WUTW() == 0U)
 {
 if ((HAL_GetTick() - tickstart) > RTC_TIMEOUT_VALUE)
 {
 if (LL_RTC_IsActiveFlag_WUTW() == 0U)
 {
 return HAL_ERROR;
 }
 }
 }
 }

 return HAL_OK;
}

To make the example work, I had to add a call to HAL_RTC_WAKEUP_Stop() before HAL_RTC_WAKEUP_SetConfig in mx_rtc.c.

 HAL_RTC_WAKEUP_Stop(); // Added line of code
 /* Configure wake-up timer */
 hal_rtc_wakeup_config_t wakeup_config;
 wakeup_config.clock = HAL_RTC_WAKEUP_TIMER_CLOCK_RTCCLK_DIV16;
 if (HAL_RTC_WAKEUP_SetConfig(&wakeup_config) != HAL_OK)
 {
 return SYSTEM_PERIPHERAL_ERROR;
 }

This does not seem to be the proper solution. Do you have any suggestions of how to address this issue?

I attached the .io2 file. The project runs on Nucleo-C562RE.

Thank you,

-Gil