wrong IS_RCC_PLLN_VALUE macro

Hi !

This issue is still not fixed in the current F4 firmware V1.25.

If USE_FULL_ASSERT is used the parameter check for a valid calculated value of PLLN=96 by STM32CubeMx fails.

The old issue was closed therefore please raise a ticket (again) - thanks !

Best regards,

Michael.

This topic has been closed for replies.

Technical Moderator

Good catch @Katzenberger.Michael ! Thanks for bringing again this limitation to our attention.

It is requested again to make the required update after reporting it to our development team.

-Amel

To give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.

Visitor II

Please fix it.

Sign up