Skip to main content
SWoo.1
SWoo.1
Visitor II
January 17, 2020
Question

Does SDK5.4 support ICS?

  • January 17, 2020
  • 1 reply
  • 535 views

After Workbench and Keil firmware was doenloaded to STM32F103RC. But it showed Unkown error when I tried to run the motor via Worknench. When stop run button was clicked it show "any stop". Anyone can tell me what happened and what should I do? Thank You

This topic has been closed for replies.

1 reply

Laurent Ca...
Laurent Ca...
Senior III
June 15, 2021

The question has been moved from the "Motor Control Hardware" section to the "STM32 Motor Control" section (the question is about the STM32 MC SDK). 

Best regards

Terms & ConditionsAccessibility statement