FOC SDK 5.4 - encoder

Hi i have configured the quadrature encoder in Motor->Sensors and set the number of pulses

and select the quadrature encoder in Drive Management->Speed/Position Feedback Management

for to finish set the correct IO pins used for the quadrature encoder in Control Stage->Digital IO. as A15 and B3.

After this, compile and load, but the motor does nos espin , what i have done wrong ?

Thanks

This topic has been closed for replies.

Senior III

The question has been moved from the "Motor Control Hardware" section to the "STM32 Motor Control" section (the question is about the STM32 MC SDK).

Best regards

Sign up