Skip to main content
Kashyap
Kashyap
Visitor II
September 2, 2020
Question

I am getting this warring message "These IPs still have some not configured or wrong parameter values:[ADC1]" when trying to generate code on ST Motor Control Workbench

  • September 2, 2020
  • 1 reply
  • 535 views

We are trying to use NUCLEO-F401RE + X-Nucleo-HM16M1 for 3-phase BLDC Motor with Encoder(Incremental). Trying to make Position mode Servo Motor Driver.

This topic has been closed for replies.

1 reply

Laurent Ca...
Laurent Ca...
Senior III
June 22, 2021

The question has been moved from the "STM32 Motor Control" section to the "Motor Control Hardware" section (the question is not about the STM32 MC SDK). 

Best regards

Terms & ConditionsAccessibility statement