I am just getting started with the NUCLEO-F303RE and X-NUCLEO-IHM16M1 evaluation boards. When I open the MC Motor control workbench, I start a new project, select the boards. I click on monitor, and am not able to connect to the board.

I installed the driver and can see it in the device manager, but have "Connection Failed Error". Anyone know what I am missing here?

This topic has been closed for replies.

Technical Moderator

Hello,

From your description, it is not obvious to me that you generated the code, compiled it and flashed it to the board.

Could you confirm that the board does contain the Motorcontrol software ?

Regards

Cedric

Senior III

The question has been set only to the "STM32 Motor Control" topic (the question is only about the STM32 MC SDK).

Best regards

Sign up