Skip to main content
MKOTE.1
MKOTE.1
Associate
April 3, 2020
Solved

Nucleo-F302R8 : USB drivers installed, jumpers configuration done, but when I connect to the PC the LED LD2 remains OFF, LD1 blinks in red, LD3 red, and the PC don't see the device (No ST-link detected). Otherwise the board is working and the motor s

  • April 3, 2020
  • 5 replies
  • 2071 views

This topic has been closed for replies.
Best answer by MKOTE.1

Dear Laurent,

The problem was in the USB cable that transmitted power but no data.

I changed the cable and it is working now.

Btw, it would be a good idea to provide the cable with the board!

Best regards,

Mohamad

5 replies

Claire O.
Claire O.
Technical Moderator
April 3, 2020

Hello MKOTE.1,

Can you please specify which SW you are using?

Thanks and best regards,

Claire

MKOTE.1
MKOTE.1Author
Associate
April 9, 2020

Hello Claire,

I tried with Motor Profiler, STM32 ST-LINK Utility, ST MC Workbench, EWARM, etc.

This is the first time I use the board, I've never seen the LED LD2 blinking.

Thanks,

Mohamad

MKOTE.1
MKOTE.1Author
Associate
April 3, 2020

Hello Claire,

I tried with Motor Profiler, STM32 ST-LINK Utility, ST MC Workbench, EWARM, etc.

This is the first time I use the board, I've never seen the LED LD2 blinking.

Thanks,

Mohamad

MKOTE.1
MKOTE.1Author
Associate
April 15, 2020

Any other suggestions? I need to be able to program the board.

Laurent Ca...
Laurent Ca...
Senior III
October 15, 2020

Dear @MKOTE.1​ 

Do you have still this problem to solve?

If not, do not hesitate to share the final solution you found.

Best regards

Laurent Ca...

MKOTE.1
MKOTE.1AuthorAnswer
Associate
October 15, 2020

Dear Laurent,

The problem was in the USB cable that transmitted power but no data.

I changed the cable and it is working now.

Btw, it would be a good idea to provide the cable with the board!

Best regards,

Mohamad

Terms & ConditionsAccessibility statement