Question
Over-current protection section
Posted on May 24, 2017 at 07:57
Hello, All:
I use (ST Motor control Workbench) parameters in power management where I set up some flow parameters, and then generate the file in Power stage, But I did not find the parameters.h file to set my parameters, why, where is it?
/*********** Over-current protection section ************/
#define OVERCURR_FEEDBACK_POLARITY EMSTOP2_ACTIVE_LOW #define OVERCURR_PROTECTION_HW_DISABLING DOUT_ACTIVE_HIGH/************************************************* ************/
There is no parameter about overcurrent.
Thank you!