Skip to main content
Dkoşa.1
Dkoşa.1
Associate
June 27, 2020
Question

ST MC Workbench code generation error

  • June 27, 2020
  • 2 replies
  • 915 views

I bought STEVAL-SPIN3201 for development. I installed ST MC-WB , CubeMX and CubeIDE to on my PC. When I tried to generate code by MC-WB it is says "STM32CubeMX not found". But as I said it is already intalled. What could be the reason?

This topic has been closed for replies.

2 replies

Laurent Ca...
Laurent Ca...
Senior III
July 2, 2021

Dear @Devrim koşal​ 

Welcome to the STM32 Community

Perhaps STM32CubeMX is found but not with the right version (V4.25 or higher).

Could you give more details to the STM32 Community about your setup -the material you use- ?

(HW and also SW: CPU(s), tools and versions, board(s), motor(s) and so on)

And more especially did you use STM32 MC tools or what version of those tolls you use (such as MC_suite, STM32 MC Motor Profile, STM32 MC SDK, STM32 MC Workbench, the used example, the origin of the base of your application source code, and so on)?

Best regards

Laurent Ca...
Laurent Ca...
Senior III
July 19, 2021

Dear @Devrim koşal​ 

Any news?

Best regards

Terms & ConditionsAccessibility statement