STEVAL-SPIN3201
The motor runs only in the specified ramp up time, after we get the "Start-up failure".
May this be caused by wrong Motor Parameters put in?
Any other setting who may cause this?
STEVAL-SPIN3201
The motor runs only in the specified ramp up time, after we get the "Start-up failure".
May this be caused by wrong Motor Parameters put in?
Any other setting who may cause this?
We are testing on a STEVAL-SPIN3201 board the motor described in attached pdf document.
Any suggestions for Motor Parameters to put in?
The Motor Control Workbench included Motor Profiler is not supporting the STEVAL-SPIN3201 board, any option to use this board to extract the motor profile?
