TFA boot failed with eMMC even with proper OTP fuses

Question

https://community.st.com/s/question/0D53W00000PoivmSAB/changing-the-emmc-pins-with-otp

I have the same pin mapping as above:

SDMMC2_CK - PE3 (AF09)
SDMMC2_D0 - PE6 (AF07)
SDMMC2_CMD - PG6 (AF10)

I programmed the OTP fuses as follows:

WORD 3: 0x23000004 (I also program SD as primary and eMMC as secondary)
WORD 5: 0x56755395
WORD 6: 0x000076A4

The problem is that even after flashing the eMMC with the TFA image as per the following procedure: https://u-boot.readthedocs.io/en/latest/board/st/stm32mp1.html#prepare-emmc

I still get nothing on the UART4 console.

We also put a scope on the SDMMC2_CK line and no clock is detected.

Does it mean the BootROM is not accessing the eMMC?

Am I missing something?

cfilipescu · Accepted Answer

the issue was resolved but I don't remember the resolution

PatrickF · Answer

Hi @cfilipescu​ ,there could be multiple causes:bad BOOT pins (please ensure it is neither 0b000 nor 0b100)badly programmed eMMCbadly eMMC setup (e.g. PARTITION_CONFIG in ext-CSD of the eMMC )badly formatted TF-A binary (especially header)bad OTP (those you listed sound ok)bad HW around eMMC (supplies, pull-ups, etc...)Could you try using CubeProgrammer to flash TF-A using USB ?Please check also https://wiki.st.com/stm32mpu/wiki/STM32MP15_ROM_code_overview#Debug_and_Error_messagesand try to get the BootROM trace using https://wiki.st.com/stm32mpu/wiki/STM32MP15_ROM_trace_analyzerRegards

Sign up

Login with SSO

Login to the community

Login with SSO

Scanning file for viruses.

This file cannot be downloaded