Skip to main content
N
NİHAT_EEE
Associate
August 11, 2023
Question

STM32F030F4P6 programming

  • August 11, 2023
  • 3 replies
  • 2967 views

Hi, I have a problem about upload program. I make size photocell with STM32F030F4P6 MCU. After I set hardware and software, I can not upload programming to MCU. I try to upload programming with ST-LİNK V2. And writing problem at console. Error is that ;

Target no device found

Error in initializing ST-LINK device.
Reason: No device found on target.

What can I do?I control connection pinout. Coming 3.3V and connection pinouts is correct. Please Can you give advice?

Thank you.

3 replies

Peter BENSCH
Peter BENSCH
Technical Moderator
August 11, 2023

Welcome @NİHAT_EEE, to the community!

Is your ST-LINK/V2 in a colourful metal box?

Regards
/Peter

In order to give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.
N
NİHAT_EEEAuthor
Associate
August 11, 2023

Yes, it is colourful metal box.

AScha.3
AScha.3
Super User
August 11, 2023

do you have any other STM board or discovery board , to test : connect and working with CubeProgrammer ?

 

"If you feel a post has answered your question, please click ""Accept as Solution""."
N
NİHAT_EEEAuthor
Associate
August 11, 2023

Yes, I try cube programmer and ST-link V2 at breadboard. İt is working both of them.

AScha.3
AScha.3
Super User
August 11, 2023

so on your breadboard its ok, you can program the cpu ?

then you have some bad or wrong connection to your target board. 

boot0 low ?

connect mode : " software reset "

 

"If you feel a post has answered your question, please click ""Accept as Solution""."
E
EmiloEmilo
Visitor II
July 22, 2025

Niekedy je potrebné pripojiť aj NRST programator s doskou.

Terms & ConditionsAccessibility statement