STM32CubeIDE for Visual Studio Code (MCUs)

During auto generation of the st-project.cmake, it seems that the import tool recursively searches the project for source files instead of using the paths defined by the project's source locations. For example, I have the following defined as my source locations. However, when the target_sources are generated, all source files in the workspace are added. The compilation then fails because the include files can not be found in the supplied include directories. If I manually remove the extra source files the build succeeds.

..

I am getting the following output in the terminal, when I hit f5what may be the issue?

Hi, When I insert a breakpoint or pause the debugger, the debugger first stops at a point where there was probably an ISR, showing the error message in the figure below, and I need to press F5 again so that the degugger goes to the breakpoint that I inserted.

I have (I believe) installed all the prerequisites and added the paths to STM32CubeMX and STMCUFinder. However I cannot use the extension as the commands are not available.​If I try to run the command via the command palette, I get a "command not found" error popup.Thanks in advance for any ideas or help to move forward.

This community Supports only the VSCode extension for STM32, for other related support cases for VSCode please log it in the corresponding MCU Community