Were are the examples for NUCLEO-H753ZI

Same as H743​

All examples for Nucleo-H743ZI work on Nucleo-H753.

New Ethernet examples are here.

not sure why but selecting these do not work. They compile and run and deploy to the board but do nothing. Also when I try to bring up the device board layout tool, nothing is shown, do I need to do an extra step, like tell it the chip I have?

if I first put in the board, then try to set the chip, it marks the board text box red.

I have the Nucleo-h753zi

it also says NUH753Zi$AT1

I do see ST-LINK V3 On the board yes.

There are 90 samples for ht743zi but none seem to work or show a device view.

maybe its just how I set this up?

I run the new project wizard

I find and select my IC

I find and select my board

Now on the example repo I see it has no idea what I just selected So I pic the board ht743zi since there are no examples for H753ZI and it loads my new project. From here I normally can click the device config tool and my IC shows up, but in this case it does not. Also when I run a project that activates the LEDs nothing flashes

but this works

I run the new project wizard

I find and select my IC

I find and select my board

make a blank project.

Here the device config tool shows my IC and if I write code to activate LEDS they work,

cube makes me miss KEIL... Will check out the links.

its using

#define USE_STM32H7XX_NUCLEO_144_MB1364

changed to USE_NUCLEO_H743ZI2

that got it

MMmm, but where is the code for the preloaded demo that blinks the three LEDs at three different frequencies and switches between them when pushing the button? That looks like a great place to start, but I can't find it.