Posted on October 01, 2015 at 14:45
First I configure the module.
void BLUENRG_Setup(void)
{
HCI_Init();
BlueNRG_RST();
Osal_MemCpy(bdaddr, SERVER_BDADDR, sizeof(SERVER_BDADDR));
/* Configure BlueNRG address as public (its public address is used) - MAC address of the device */
ret = aci_hal_write_config_data(CONFIG_DATA_PUBADDR_OFFSET, CONFIG_DATA_PUBADDR_LEN, bdaddr);
if(ret){ /*PRINTF(''Setting BD_ADDR failed.\n''); */ }
/* Init BlueNRG GATT layer */
ret = aci_gatt_init();
if(ret){ }
/* Init BlueNRG GAP layer as peripheral */
ret = aci_gap_init(GAP_PERIPHERAL_ROLE, &service_handle, &dev_name_char_handle, &appearance_char_handle);
if(ret != BLE_STATUS_SUCCESS){ }
ret = aci_gatt_update_char_value(service_handle, dev_name_char_handle, 0,
strlen(name), (uint8_t *)name);
if(ret){ }
ret = aci_gap_set_auth_requirement(MITM_PROTECTION_REQUIRED,
OOB_AUTH_DATA_ABSENT,
NULL,
7,
16,
USE_FIXED_PIN_FOR_PAIRING,
123456,
BONDING)
