iis2iclx fifo only trigger once I want to read the FIFO of IIS2ICLX, but I found that INT1 only triggers once when the power is first turned on. This is my initialization code. Is there anything wrong with this initialization?I triggered the interrupt through the rising edge. Once the interrupt occurred, an event would be sent. I measured the level of the interrupt pin, and it remained constant.iis2iclx_xl_full_scale_set(&dev_ctx, IIS2ICLX_500mg);
/* Configure filtering chain(No aux interface)
* Accelerometer - LPF1 + LPF2 path
*/
iis2iclx_xl_hp_path_on_out_set(&dev_ctx, IIS2ICLX_LP_ODR_DIV_10);
iis2iclx_xl_filter_lp2_set(&dev_ctx, PROPERTY_ENABLE);
iis2iclx_fifo_xl_batch_set(&dev_ctx, IIS2ICLX_XL_BATCHED_AT_104Hz);
iis2iclx_xl_data_rate_set(&dev_ctx, IIS2ICLX_XL_ODR_104Hz);
s_sample_rate = 104.0f;
iis2iclx_fifo_watermark_set(&dev_ctx, 112);
iis2iclx_fifo_mode_set(&dev_ctx, IIS2ICLX_FIFO_MODE);
iis2iclx_pin_int1_route_t int1_rout
