My code doesn't run without debug mode (CubeIDE) Hi,i am using STM32CubeIDe in my project. i am using STM32F030 as transmitter and STM32F4 as a receiver. When i run my code in debug mode both of them work properly. But when i press terminate and re-insert my ST-LINK device i can't see any data in my receiver (also i see that receiver and transmitter connects). How can i download the code and use it without debug mode?Here is my code. (In main, there are only pin configurations, so i didn't post it)#include "main.h" //buraya don
#include "stm32f0xx_hal.h"
#include "dht22.h"
uint8_t nem_byte1, nem_byte2, sicaklik_byte1, sicaklik_byte2,checksum, verilerin_toplami;
uint16_t nem, sicaklik,sicaklik1,nem1,timer_sayac_degeri;
void delay_ticks(uint32_t ticks)
{ //SYSTICK TIMER 24 BIT
SysTick->LOAD = ticks; //girilen süre için gerekli tick sayısı
SysTick->VAL = 0;
SysTick->CTRL = SysTick_CTRL_ENABLE_Msk;
SysTick->CTRL &= ~SYSTICK_CLKSOURCE_HCLK_DIV8;
SysTick->
